Purpose: The process engineer is responsible for maintaining daily production uptime of fully automated molding machines, including all subsequent pre- and post-mold operations such as trimming, insert loading, and automated part handling. The process technician must have a good fundamental knowledge of the injection molding process, raw material, test methods, processing controls, and secondary equipment. This position directly reports to the Plant Manager.
Duties & Responsibilities: - Perform all start-up, shutdown, and troubleshooting of the molding process during normal production run.
- Monitor all process parameters and peripherals in injection molding cell, including driers, thermal control units, and testing equipment to ensure correct operation and performance
- Coordinate and/ or set up all secondary and auxiliary equipment as needed for each job
- Ensure that materials requiring pre-drying are managed properly.
- Assist with all mold insert changes
- Coordinate and assist with new mold samplings including the molding process and the creation of full documentation on processing parameters.
- Communicate with management, quality assurance, and shop floor daily to discuss all modeling related issues
- Assist with the planning, purchase, installation, and qualification of new production equipment including injection machines; automation and robotics; material handling; and related auxiliary equipment system
- Assist set-up technicians and material Handlers as needed
- Implement technical solutions to meet customer cost, quality, and delivery expectations
- Monitor and document issues with injection molds, and make recommendations for repair and refurbishment based on production requirements
- Ensure that the production activities are carried out in accordance with approved procedures
- Promote safety, quality, and environmental awareness at all times
- Always follow department operational procedures.
- Operate the machines as needed
Required Knowledge, Skills, & Abilities: - High school diploma or equivalent qualification.
- A minimum of 3 years' experience in a similar role (Preferred).
- Strong mechanical aptitude and scientific molding experience would be beneficial
- Good communication/Interpretation skills and attention to detail
- Ability to work in a fast pace, high change environment, with limited supervision
- Demonstrated ability to start up, operate, and shut down injection molding machines and related process equipment
Pay Rate : $85,000 Yearly
