JOB TITLE: PROCESS ENGINEER (Asset Engineer)

Location: Pasadena TX

JOB PURPOSE

The primary role of this position is program development and implementation of a Process Engineering strategy, five year capital planning, process optimization and some daily operation support.

RESPONSIBILITIES AND ACCOUNTABILITIES

· All job activities should be executed in a safe and efficient manner consistent with the INEOS 20 Principles.

· Embrace INEOS Life Saving Rules in all aspects of the job.

· Responsible for the integrity management of assigned equipment.

· Complete all required training on schedule.

· Develop and implement a Unit Health Monitoring program.

· Support integrity of critical assets and protective systems, maintenance, and periodic

review of the critical equipment list, operating/integrity envelopes, applicable damage mechanisms, and inspection plans.

· Define and periodically review Operating Envelopes of assigned equipment.

· Assist with development of five-year capital plan.

· Develop long term process engineering improvement strategy for the site.

· Write and implement MOCs, including small and large Capital Projects.

· Process Engineering resource for PHA’s.

· Establish communications with appropriate operations personnel.

· Report investigation results with appropriate conclusions and recommendations.

· Main liaison between site and C3D Process Technology Group.

· Assist with tracking yields, production, and feed stock information into month end closing. Back up for the month end closing.

· Site representative for the C3 Process Safety Handbook.

· Maintain open communications with plant operators to ensure continuity of safe, efficient operations.

· Work with Operations department to troubleshoot operational issues and identify process problems.

· Assist in developing and reporting Production KPIs, monitor catalyst performance, identify process bottlenecks, use process data to identify long term trends and shifts

· Work with the controls group on Alarm Management and Rationalization efforts and implementing controls improvements to support Smart Manufacturing efforts.

· Provide input for daily shift Instructions.

· Develop process flow diagrams.

· Drive alarm management to completion and provide support for continuing success.

· Solicit input from all appropriate resources (engineering, operations, and maintenance) and balance conflicting requirements.

· Direct, coordinate, or participate in Process Safety Review or Management of Change process.

· Initiate communications with affected areas and produce progress reports.

· Lead RCA’s as needed.

· Provide engineering assistance and expertise to Operations and Maintenance as needed.

· Assist in meeting regulatory requirements assigned to the production facility including EPA/Texas Commission on Environmental Quality (TCEQ), OSHA, and DOT regulations.

EDUCATION/EXPERIENCE REQUIRED

· Bachelor’s Degree or higher in Chemical Engineering

· Minimum of 5 years of experience.

SKILLS/COMPETENCIES

· Strong written and oral communication skills

· Strong computational and data analysis skills

· Strong IT skills and Aspen process simulation software

· Strong problem-solving skills

· Good negotiator and influencer

· Good team leader and motivator

· Solid understanding of financial calculations and their impact on the bottom line

· Willingly takes the lead when challenges occur

PHYSICAL REQUIREMENTS

· Ability to climb fixed ladder cages at heights of 30 ft. at a time. Total of 200 ft. (employee may need ladders as means of egress during emergency).

· Ability to climb 6 flights of stairs.

· Ability to enter enclosed spaces through 18” man-way for cleaning and inspection purposes.

· Ability to lift 50 lb.

· Ability to wear required PPE: Hardhat, safety glasses, chemical goggles, face shield, rigid safety shoes/boots, full/half face cartridge masks.

· Ability to work length of time outdoors/ inclement weather.

· Job specific: Climbing, balance, bend/stoop, kneeling, reaching, lifting, carrying.

· Need to evaluate understanding of proper lifting techniques and body mechanics.